Dell 5100cn Color Laser Printer - Manual (Page 110)

IP Filter
Purpose:
To specify the reception of data from certain IP addresses for blocking. You can set up to five IP addresses. The change
becomes effective after the printer is turned off and then on again.
Values:
Filter n
(n is 1 to 5.)
Address
Sets the IP address for Filter n.
Mask
Sets the mask for Filter n.
Mode Off*
Disable the IP Filter feature for Filter n.
Accept
Accepts an access from specified IP address.
Reject
Rejects an access from specified IP address.
Init NVRAM
Purpose:
To initialize network data stored in NVRAM.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings for
Network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto*
Used when auto-detecting the PostScript communication protocol.
RAW
Used when no special processing is required for data.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
USB
Use the USB menu to change printer settings affecting a USB port.
Adobe Protocol