Dell 5100cn Color Laser Printer - Manual (Page 33)

Community
Name (Trap)
*1
Specifies the community name used for trap up to 31 alphanumeric characters.
The original settings will remain valid if no input is made. Characters entered for Community Name
(Trap) in previous settings will not be displayed on the screen. The default Trap Community is " "
(NULL).
Trap
Notification
(IP)
Select the check box to notify trap occurrence. In this case, specify the IP address and IP socket in
the nnn.nnn.nnn.nnn:mmmmm format. Each section of nnn.nnn.nnn.nnn is a value between 0 and
255. Note that values 127 and 224 to 254 are not valid for the first three-digits only. IP socket
mmmmm is a value between 0 and 65535.
Trap
Notification
(IPX)
*2
Select the check box to notify trap occurrence. In this case, specify the IPX address in the
nnnnnnnn.mmmmmmmmmmmm.llll format. IP network nnnnnnnn is a hexadecimal value between 0
and ffffffff, IPX node mmmmmmmmmmmm is a hexadecimal value between 0 and ffffffffffff and IPX
socket llll is a hexadecimal value between 0 and ffff.
Authenticate
Error Trap
Select the check box to notify Authenticate Error Trap.
*1 The default value of each items can be changed by using Dell Printer Configuration Web Tool.
*2 An optional multi protocol card is required to use.
IP Filter
Purpose:
To configure the detailed settings for the IP Filter used for LPD and Port9100. This page can be linked from LPD and
Port9100 settings on the TCP/IP page.
Values:
Address Sets the address in the address field. Enter a numeric value between 0 and 255 in each field of
"aaa.bbb.ccc.ddd." However, 127 and 224 to 254 cannot be used to "aaa."
Address Mask Sets the Address Mask in the Mask field. Enter a numeric value between 0 and 255 in each field.
Active
Mode
Permit Permits printing from specified network address.
Disabled Disables the IP Filter feature for the specified IP address.
Reject Rejects printing from specified network address.
When you make the settings for the filter, enter the IP address of the IP Filter in the Address field and the Subnet Mask
in the Address Mask field. Enter a numeric value between 0 and 255 in each field. "*" is appended to the current value.
Setup Procedure
You can set up to a maximum of five items and the first item takes priority. Enter the shortest address first before
proceeding to the next longer address when setting multiple filters.
The following section explains how the IP Filter operates.
IP Filter Procedure
Enabling Printing From a Specified User
The following describes the procedure to enable printing only from the "192.168.100.10" IP address.
Procedures:
1. Click the first column of Access List row 1.
2. Enter "192.168.100.10" in the Address field and "255.255.255.255" in the Address Mask field.