Dell 5100cn Color Laser Printer - Manual (Page 142)

Job too Large
Press Set
current print job.
print job, and conduct the next print job, if any.
· Press Cancel to cancel the current print job.
· Press Menu to open the Stored Print and delete
the holding job.
· To avoid this error in the future, do the following:
· Delete unnecessary fonts, macros, and other data
in printer memory.
· Install additional printer memory.
See " Accessing Held Jobs From the Operator Panel "
Disk Full
016-980
Job too Large
Press Set
RAM disk memory is full and
cannot continue processing the
current print job.
· Press to clear the message, cancel the current
print job, and conduct the next print job, if any.
· Press Cancel to cancel the current print job.
· Press Menu to open the Stored Print and delete
the current job.
· To avoid this error in the future, do the following:
· Reduce the number of print pages such as splitting
the print data.
· Increase free memory space by deleting
unnecessary data in the RAM disk.
See " Accessing Held Jobs From the Operator Panel "
PCL Request
016-720
Data Violation
Press Set
Error relating to PCL emulation
problems occurs.
· Press to clear the message, cancel the current
print job, and conduct the next print job, if any.
· Press Cancel to cancel the print job.
Invalid Job
016-799
Data Violation
Press Set
When the configuration of the
printer on the printer driver does
not conform to the printer you are
using, this message appears.
· Press Cancel to cancel the print job.
· Make sure that the configuration of the printer on
the printer driver conforms to the printer you are
using.
Ready to Print
010-421
Replace Fuser
Soon
The fuser needs to be replaced. Replace the fuser.
See "
Replacing the Fuser and Separator Roller ".
Ready to Print
094-422
Replace Transfer
Roller Soon
The transfer roller needs to be
replaced.
Replace the transfer roller.
See "
Replacing the Transfer Roller ".
Replace Drum
094-402
Imaging Drum
Replace soon
The imaging drum needs to be
replaced.
Replace the imaging drum.
See "
Replacing the Imaging Drums "
CTD Sensor Dirty
092-310
Clean
CTD Sensor
The printer's automatic density
control (CTD) sensor needs to be
checked soon.
Check the printer's CTD sensor.
See " Cleaning the Automatic Density Control (CTD)
Sensor "
Ready to Print
193-700
non-DELL Toner
Installed
The printer is in the custom toner
mode.
When some of the toner cartridges reach the end of
their lives, you cannot continue printing.