Nikon 35MM Film Scanner LS-10E - Manual (Page 36)

[a] [b]
Fig. 3.5 SCSI connection on the LS-10
Connexion SCSI du LS-10
SCSI-Stecker an LS-10
Procedure 3.1 provides step-by-step instructions for
physicaliy instaliing the LS-10 internal-mount scanner.
Please read through this chapter before the actual
installation of the scanner.
Procedure 3.1__________________
Installing the internal-mount scanner
into the drive bay
Step 1 Connect the SCSI cable to the LS-10
Connect one end of the flat 50-pin SCSI cable to the
50-pin SCSI connector on the rear of the LS-10 as shown
in Figure 3.5. Insure that Pin 1 of the cable is aiigned
with Pin 1 of the scanner.
[a] LS-10 rear side
[b] SCSI connector
[c] SCSI flat cable (SCSI cable showing keying)
The connectors on both the scanner and on the cable
are protected with a protruding tab to force the
connector to mount properiy. Note that Pin 1 on the
scanner connector and the cable connector is marked
with a triangie, and the wire associated with Pin 1 has a
red stripe on it. Do not force the cable connector into the
scanner. It should snap into piace with a bit of force. Be
careful to have the connector on the cable positioned
paraliel to the connector on the scanner before applying
force. This wiil reduce the risk of bending any pins.
Warning! .. <
,,Make sure Pin .1 marked on the scanner connector
mates with Pin 1 of the flat cable connector.
Step 2 Terminating the SCSI
LS-10 needs the SCSI termination. Refer to “3-4
Terminating the SCSI chain” in this chapter for more
information.
Step 3 Loosen the lock down screws
On one or both sides of the drive bay opening are
iocking screws. These may be positioned so that they
block the access to the openings in the drive bay where
the rails will slide in. Loosen these screws so that the
metal tab does not block access to the openings. It may
be necessary to remove these tabs. Keep them handy
because they will be repositioned in Step 8 below.
36