Nikon 35MM Film Scanner LS-10E - Manual (Page 8)

1-7 Notes on Use
Power source
1. Always use the power source of 100 — 240 V,
50 — 60 Hz.
Use the power cord subject to the voltage of power
source, and if you use over AC125 V:
* the plug must be rated for AC250 V I S A
(NEMA6P-15).
• the insulation of the cord must be more than SVT
type, and be a suitable cord of at least AWG18 and
approved under safety regulations of the nations in
which it is used.
2. Once the power source is turned off, do not turn it
on until at least 5 minutes have passed.
3. Don’t unplug the unit while the power is on.
4. Don’t hold the cord itself when unplugging the unit.
5. The power source must be grounded. A joint ground
with other instruments is indispensable, or else a
ground loop, which can cause electrical shocks and
electrical noise, may result.
6. Don’t unplug the peripherals while the power is on.
7. Don’t carry the main unit while the power is on.
* Be sure to use the unit in a horizontal orientation only;
a perpendicular orientation will cause misoperation.
* Don’t use a slide mount more than 3 mm thick. If the
slide mount is not flat on its surface, you may feel
some roughness when mounting or unmounting the
slide.
* Don’t force the slide-mount or strip film holder into or
out of the scanner if it does not move smoothly.
* When moving the scanning stage, don’t touch or
unmount the strip film holder.
* Don’t disassemble the main unit. It is dangerous to
touch the internal components because of high-voltage.
* Don’t put the things inside the unit. Flammable
materials, metals, water etc., will cause fire, electrical
shock, damage and misoperation.
In emergency
If you find something unusual, such as abnormal noise,
smells or smoke, turn off the power switch, and take the
unit to the dealer from whom you purchased it.
8