7 setting up a scsi chain with the ls-10 – Nikon 35MM Film Scanner LS-10E User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
[d]
[g] [e]
Fig. 3.11 The internal-mount SCSI bus
Le bus interne SCSI
Der interne SCSI-Bus
3-7 Setting Up a SCSI Chain with
the LS-10
The LS-10 scanner is equipped with one SCSI 50-pin
connector. When the scanner is connected as the only
other device on the chain, or as the last device on the
chain, then the connector of the 50-pin cable will end at
the scanner. This case is shown in Figure 3.11.
[a] Computer SCSI controller
[b] Computer internal SCSI termination set
[c] Computer SCSI connector
[d] SCSI cable
[e] LS-10 SCSI connector
[f]
LS-10 scanner
[g] LS-10 SCSI termination switch
Typically, the scanner will be the only peripheral on the
internal SCSI bus. If this is the case, the 50-pin cable
provided will work.
In some cases, as shown in Figure 3,11, the LS-10 will
not be the only peripheral on the internal SCSI bus.
When this occurs, the SCSI cable provided will not work.
A special cable with a connector stamped in the center
of the cable as well as a connector stamped on both
ends of the cable will be required. This special cable is
shown in Figure 3.12.
[h] SCSI flat cable (optional)
[i] SCSI 50-pin connectors
[|] Connector protection key
Fig. 3.12 The special cable (not provided) required to
connect the LS-10 in the center of a SCSI
chain
Le câble spécial (non fourni) nécessaire pour
connecter le LS-10 au milieu d’une chaîne
SCSI
Das zum Anschluß des LS-10 in der Mitte der
SCSI-Kette benötigte Spezialkabel gehört
nicht zum Lieferumfang
50