AVer NXU Lite User Manual
Page 106
98
The recording modes are listed below:
-
Always Recording
Record the video from the selected camera and save it to the designated storage path (see also
-
KeyFrame Recording
Only record one frame per second.
-
Motion Recording
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop based on
the Start Record Prior and Stop Record After settings.
i
The NVR system only record in key frame for pre-recording.
-
Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is detected and
if there is no motion, it records at the minimum frame rate setting.
-
Voice Detecting Recording
NVR system will record when the voice exceeds the intensity value in Voice Detection setting.
-
No Recording
The system
won’t do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is detected.
When it detects a motion, a green triangle mark would appear at the upper left corner of the screen.
Click Advanced button to select the area for motion detection. Click Region 1/2/3 button, and then,
click-and-drag an area on camera screen for motion detect. To adjust motion detect sensitive, scroll
the Sensitivity 1/2/3 bar. Click OK to save and exit the setting window. To reset all setting, click
Default.
(4) Mask/Shield Edit
Mask, mark an area on the screen to disregards the motion in the marked area and to only monitor
outside the marked area. As for the Shield, it covers an area on the screen and the covered area
would not be visible on the screen and recorded.
To Mask/Shield an area on the screen
1. In the Mask/Shield Edit section, activate the Enable Mask/Enable Shield check box.
2. In the Edit section, select between Mask or Shield and click the button.
3. Click and drag a frame on the (5) Video Screen to create Mask or Shield area.