AVer NXU Lite - Manual (Page 166)

158
To Setup CMS Setting
Next to the Send to CMS check box, click Detail. Click OK to accept the new settings and
Cancel to exit without saving.

CMS: Select the camera to enable/disable sending the video to CMS.
 Matrix: Select the camera to enable/disable sending the alarm event video to CMS. The
CMS site need to setup a matrix channel to receive the alarm event from NVR server
site(please refer to CMS manual for detail)

Use transmitting IP address list: Mark to enable and Set specific IP address of CMS
server to receive the alarm video. When this function has enabled, only the IP address of
CMS has added in Allow list can receive the alarm video from the this DVR server. The allow
list is up to 32 IP addresses.