Elay, Etting – AVer NXU Lite User Manual
Page 118
110
3.8 Relay Setting
The I/O device must be installed to use this function.
To set the Relay Setting:
1. Click the drop-down list and select the relay ID number.
2. Enter relay name.
3. Mark Enable to enable the selected relay. If user wants to apply the setting to all relays, click
Apply to all button after complete the setting of the relay.
4. The system automatically detects the card and input number.
User can enter a short description
for this relay in Description frame.
5. To set all relay devices for same setup setting, mark Enable and click Apply all.
6. Mark Enable Pulse trigger the relay will be triggered depends setting of Interval Time and
Retrieve Time. Interval Time is a time gap for the relay will be triggered, for example: the relay
will be triggered every 3 seconds if interval time is set to 3 seconds. Retrieve Time is the time that
relay is staying in trigger status, for example: when relay has been triggered and it will continuous
in trigger status for 2 second if retrieve time is set to 2 seconds.
7. In the test section, click Test to trigger relay. Red is high and Green is low.
8. Click OK to exit and accept the setting and Cancel to exit without saving the setting.
9. Click External IO to configure external I/O device if it is available (see also
). When
external I/O is set and it will be available in drag down list for selecting.