AVer NXU Lite - Manual (Page 62)

54
10. Show moving direction indicator line: enable/disable to show the direction line when uses
mouse drag on screen in PTZ mode.
11. Iris: To adjust the iris of IP PTZ camera. It may not support that depends on brand of the PTZ
camera.
12. OSD:
To allow call out IP PTZ camera factory’s OSD setup menu. The OSD setup menu may vary
that depends on the brand of IP PTZ camera.
13. When is done, click OK to save the setting or Click Cancel, to leave without saving the new
setting.
14. When PTZ camera is enabling, user can control PTZ camera by using the mouse and on screen
PTZ control bar.
15. Click the channel that has supported and enabled the PTZ function. And then, click PTZ button on
preview UI. The PTZ control panel will show up on the screen.
i
User can move the on screen PTZ control panel to any position of screen