AVer NXU Lite - Manual (Page 123)

115
4. In (3) Conditions , you can set “Trigger if any” to activate if it falls to one of the conditions or
“Trigger if all” to activate if it falls to all conditions.
- Motion Detected: select and click on the camera number (01 to 16) to set the condition for
the system to alarm. Right-click on the camera number to setup the system to send out the
alarm when motion has been detected last the time that user has entered in Continuous
trigger duration.
- In Video Loss, click the camera number (01 to 16) to set the alarm condition when video is
lost. Right-click on the camera number (01 to 16) to setup the system to send out the alarm
when video has been lost to last the time that user has entered in Continuous trigger
duration.
5. In (4) IP Camera Sensor to configure sensor status of IP camera. Click High/Low to set sensor
status to high or low.
- Continue trigger duration: Set a time period for system to send out the alarm when sensor
has been trigger and stay in the same status for a period.