AVer NXU Lite - Manual (Page 156)

148
Record Setting
In the Recording setup window, click OK to accept the new settings, click Exit to exit without saving,
and click Default to revert back to original factory setting.
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable the
ALL check box. To select more than one camera, Right click on the camera icon. To select one
camera only, Left click on the camera icon. The camera icon turns red when it is selected.
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select the
recording mode and click the  button. If you want to only record at a particular time, click the colored
block beside the recording mode then click on the time blocks. When the system starts recording a red
triangle mark would appear at the upper left corner of the screen. The recording modes are listed
below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path
- Motion Recording
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop based
on the Start Record Prior and Stop Record After settings.
- Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is detected
and if there is no motion, it records at the minimum frame rate setting.
- Voice Detection Recording
NVR system will record when the voice exceeds the intensity value in Voice Detection setting.
- No Recording
The system
won’t do any recording.