Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 41)

40
安装远程界面控制器（可选）
Mounting the Optional Remote Interface Controller
1.将远程界面控制器背面的通信电缆拔出。（图1）
Fig. 2
Disconnect the communication cable from the back of
Remote Interface Controller. (Fig. 1)
a)将通信电缆从墙上或天花板上接到控制器的
安装地点。
a) Install the communication cable within the wall
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
b)将远程界面控制器安装在坚固表面上，注意要远离
门、角落、出气口、通风口或加热设备。请勿将控
制器直接安装在锅炉房外墙或紧邻锅炉房的墙上。
b) Mount the remote interface controller on a solid surface
away from doors, corners, air outlets, drafts or heat
generating equipment. Do not mount the Remote
Interface Controller directly on an outside wall or wall
adjacent to a boiler room.
2.拆下控制器背板，在安装位置上做好标记。（图2）
2. Remove the back plate of the controller and mark the
mounting points at the desired location. (Fig. 2)
标记出通信电缆通过的地点，准备 钻 孔。墙孔直
径应足够安装控制器后盖，以3.8毫米左右为
宜。（图3）
a) Mark the location of the communication cable
connection as this area will require sufficient
clearance for instance, a 3.8mm hole in the wall for
flush mounting of the back plate. (Fig. 3)
Fig. 1
Fig. 3