Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 52)

51
设定远程感应器或恒温
器
Set up remote
sensor
or thermostat
10号设定项
Setting 10

使用模式按钮进入10号设定项。
 Press “Settings” button to advance to Setting 10.

使用向上或向下键调整设定。
 Press the “Up” or “Down” arrow buttons to
adjust to the desired setting.
远程感应器（Remote sensor）
Remote sensor
远程界面（Remote interface）
Remote interface
本地界面（Local interface）：只使用本穿墙
式系统
Local interface – WG25 only
平均（Averaging）：需事先调整跳线。请参
考第45页。
Averaging – Jumper position within sensors
must be adjusted. See page 45.
室内感应器标定
Room sensor
calibration
15号设定项
Setting 15
使用模式按钮进入15号设定项。
 Press “Settings” button to advance to Setting 15.

使用向上或向下键进行设定。最大值为+5，最
小值为-3，出厂默认值为0。感应器标定将对
温度读数产生影响。

 Press the “Up” or “Down” buttons to adjust to
the desired setpoint. Maximum setting is +5,
minimum setting is -3. Factory default is zero
(0). Sensor calibration setpoint changes the
actual display reading (temperature only) by
the value of this setting.
例如：感应器读数为2摄氏度
Example: Sensor reading = 2 Deg C
若将此处值设为+4
Setting 15 Set to +4
此时屏幕将显示14摄氏度
Display reading = 14 Deg C
FOR SERVICE MANUAL ONLY