Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 44)

43
Fig. 3
Fig. 4
Fig. 5
Fig. 6.
2. Mount the Remote Sensor on a solid surface away from doors, corners,
air outlets, drafts or heat generating equipment. Do not mount the
Remote Sensor directly on an outside wall or wall adjacent to a boiler
room. Use a piece of foam insulation behind the sensor to insulate it
from a hot or cold surface. The recommended height is 1,2 to 1.5
meters above the finished floor.
3. 用产品附带的专用扳手卸下封盖上的六角螺丝，拆下封盖。（图
2）在酒窖墙上标记出安装位置与电缆通过的位置。准备 钻
孔。电缆孔直径应足够安装感应器后盖，以3.8毫米左右为宜。
3. Remove the sensor cover plate by removing the two allen head screws
at the top of the cover using the allen head wrench provided in the
kit.(Fig.2) Mark the mounting points at the desired location within the
wine cellar. Also mark the location of the communication cable
connection as this area will require sufficient clearance, for instance
3.8cm hole in the wall for flush mounting of the sensor plate
4.钻两个直径为0.32厘米的孔，将本品自带的膨胀螺栓插入墙
体。如将感应器安装在墙柱或支架上，则无需使用膨胀螺
栓。（图3）
4. Drill two .32cm holes and insert anchors (provided) within the
mounting surface. Anchors may not be required if securing to a
wall stud or racking system. (Fig. 3)
5 将通信电缆插入远程感应器后部。使用产品自带螺丝（2
枚）将感应器固定在墙上。（图4）
5. Plug in the communication cable to the back of the Remote
Sensor and attach to the wall using the two screws provided in
the kit. (Fig. 4)
6.将远程感应器电缆与远程界面控制器电缆插入WG设备上
的分线器中。（图5）
6. Plug the Remote Sensor cables into the splitter device at the
WG unit along with the communication cable for the Remote
Interface Controller. (Fig. 5)
提示：如需在酒窖中安装多个远程感应器，重复以上
步骤安装设备后盖好封盖即可。在使用多个感应器
时，请务必调整感应器跳线，使其提供正确的温湿度
平均读数。请参考第51页的跳线设置。
NOTE: If using multiple Remote Sensors in one wine
room, continue to mount the remaining sensors
before installation of the sensor cover plates. When
multiple sensors are used, the sensor jumper position
must be adjusted in order for proper averaging of
temperature and humidity readings. See page 28 for
jumper set up.