Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 42)

41
3.钻两个直径为2厘米的孔，将产品自带膨胀螺栓
拧入墙体。如将控制器安装在墙柱或支架上，则
无需使用膨胀螺栓。
3. Drill two 2cm holes and insert anchors (provided)
within the mounting surface. Anchors may not be
required if securing to a wall stud or racking system.
4.将通信电缆插入远程界面控制器后部。（图4）
4. Plug in the communication cable to the back of the
Remote Interface Controller backing plate. (Fig. 4)
a) 使用产品自带螺丝（2枚）将控制器固定在
墙上。（图5）
a) Attach backing plate to wall using the two
screws provided with the system. (Fig. 5)
5.盖好前盖。（图6）
5. Re-install plastic face plate on to backing
plate. (Fig. 6)
Fig. 4
Fig. 5
Fig. 6