Reloading a recording paper – Panasonic Panafax UF-260 User Manual
Page 105
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
:-s.
Reloading a Recording Paper
Your facsimile machine uses a roll of special recording paper, you can easily load
paper yourself by following the steps below.
1. Open the Receiving Unit (Control Panel) by depressing the latch button.
12
2. If there is the used roll inside, lift it out and set a new roll in its place. Be sure
the direction of the roll is as shown below. Draw out a few length of recording
paper between the guide plates of the cutter section until it projects outside the unit.
3.
Close the receiving unit carefully by pressing both ends gently until you hear the
cover lock into position.
The recording paper projecting from the unit will be cut automatically. Remove
this cut paper.
103