Setting up your machine for reiayed transmission, Setting up your machine for relayed transmission – Panasonic Panafax UF-260 User Manual
Page 121
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
:
t
Setting Up Your Machine for Reiayed Transmission
To set up your machine for Relayed Transmission, use the procedures oh the following
pages to set the eight parameters listed below. Some parameters (e.g.. Relayed XMT
Fax Parameter) are only set once, but others must be set separately for each station
in the Relay Network.
1. Relayed XMT Fax Parameter:
This switches the Relayed XMT function ON or OFF.
2. Own Telephone Number:
The full telephone number should be entered.
3. Network Address:
End Receiving station telephone numbers set in an Initial Sending station may be
different from the numbers set in a Relay Station. To send a fax to an End Receiving
station via a Relay Station each station in the network must be identified with a certain
code which does not vary depending on where you call from. The code is the Network
Address, which consists of a four-digit number and is assigned to a One-Touch/ABBR
number.
4. Network Password:
A four-digit number which prevents unauthorized (outside) stations from accessing
the Relay Station and using its memory. Every station in the network should set the
same Network Password.
5. One-Touch/ABBR Numbers:
The One-Touch or AB6R number you set must represent the fax number of a particular
station in the network as seen from your station.
6. Relay Station Parameter (Yes/No):
Set “Yes” if the particular station you are recording is a Relay Station. If you are
connected to more than one Relay Station in series, set “YES” only for the first Relay
Station.
7. Relay Address:
A two-digit number which identifies the Relay Station your machine will use. Your
machine may be connected to more than one Relay Station in parallel, but when
you use Relayed XMT your machine will only send documents to the Relay Station
identified by the Relay Address.
8. One Station XMT (Relay/Direct) Parameter:
If you send a document to only one End Receiving Station, you can set your machine
to transmit directly to that station, without going through the Relay Station, by selecting
“Direct.“ Set “Relay” if you always want to go through the Relay Station.
13
119