Panasonic Panafax UF-260 - Manual (Page 41)

Error Correction Mode (ECM)
ECM mode provides error free copy when your fax machine is connected with a
receiving fax machine which has ECM mode capabiiity and your ECM mode is set
to ON. The transmission time required in the ECM mode is the same as the normal
G3 mode in most cases.
Your machine is preset to ECM=ON. If the telephone line is poor, then the
transmission wilt take longer because the machine will have to retransmit the lines
that have errors. In the case where the transmission time is more important than the
quality of the received copy, you may set your fax machine to ECM - OFF. This
will inhibit the ECM mode for the transmission regardless of the capability of the
receiving machine. To set ECM = OFF,
1 MODE
c:- II -t- )
DOCUMENT SET
ECM=ON
repeatedly.
DOCUMENT SET
ECM=OFF
To return to ECM - ON, press SELECT
again.
You can now dial by pressing TEL/PIAL
and a full number, a One-Touch key,
and two digits, or ABBR REDIAL
fiOT€
1. After changing the ECM setting, you can
a) return to standby with I STOP I.
b) start a different series of settings by pressing RESOLUTION 1, ORIGINAL
I STAMP I. I HALF TONE 1, MODE [□[+], or I FUNCTION
2. To change the preset ECM position, see page 27.
39