Cleaning or replacing the fluorescent lamp – Panasonic Panafax UF-260 User Manual
Page 109
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cleaning or Replacing the Fluorescent Lamp
If the receiving party reports that the received documents were black, or contained
black bands, try making a copy on your unit. If the copy is black or has black bands,
the fluorescent lamp is probably dirty or defective and must be cleaned or replaced.
WARNING:
The fluorescent lamp is too hot to touch just after being turned off. Before replacing the
lamp, wait 5 minutes or more after turning the power switch OFF.
1. Make sure the battery switch is ON, then turn the power OFF (O). Unplug the
power cord. Remove the ADF tray and handset. Stand the machine up and remove
the Bottom Board Unit screws.
12
Bottom Board Unit
Instruction Seal
£• Open the Bottom Board Unit towards you. Rotate the fluorescent lamp and remove
it from the unit. When inserting a cleaned or new fluorescent lamp, make sure
that the transparent part faces you and the manufacturer's mark (A) is at the
left hand corner. Close the Bottom Board Unit and replace the screws. Return
the machine to its original position and reset the ADF tray and handset. Plug the
power cord then turn the power ON (D).
107