ClearOne comm CONVERGE SR 1212 - Manual (Page 241)

236
reserved unsigned Integer 2 0
label string 12 1 – 12 characters
Clear = clear the label
(null to query in text)
dEVICESuBTyPE – Sets the Subtype of a Connected Device
this command enables/disables or reports the current type of device connected to an input or output.
Command Form : DEVICE dEVICESuBTyPE <Channel> <group> [value]
Argument Type Size Values units
Channel Channel 1 see Groups and Channels
group group 1 1, 2, 3, 7 (I, o, m, l)
value unsigned Integer 2 (null to query in text)
dEVICETyPE – Sets the Type of a Connected Device
this command enables / disables or reports the current type of device connected to an input or output.
Command Form : DEVICE dEVICETyPE <Channel> <group> [value]
Argument Type Size Values units
Channel Channel 1 see Groups and Channels
group group 1 1, 2, 3, 7 (I, o, m, l)
value unsigned Integer 2 (null to query in text)
dFLTm – Default Meter
this command selects/reports the setting of the default meter on the front panel.
Command Form : DEVICE dFLTm [Channel group position]
Argument Type Size Values units
Channel Channel 1 see Groups and Channels
(null to query in text)
group group 1 1, 2, 3, 7, 16, 17 (I, o, m, l, t, r)
position meter type 2 1 – 4, as applicable for group
see meter Type definitions
dIAG – Diagnostic Commands
this command is used to return status and diagnostic information. It is intended to be used as a text command only.
This is a query only command.
Command Form : DEVICE dIAG <Channel> <group> [value]
Argument Type Size Values units
Channel Channel 1 see Groups and Channels
group group 1 23 (J)
value unsigned
short 2 0 = list of current commands
(J) power amp
1 = Fan/temp
2 = noise gate
3 = Feedback nodes
Information string 80 Diagnostic string
(alWays null In text)