ClearOne comm CONVERGE SR 1212 - Manual (Page 265)

260
PANGT – PA Noise Gate Threshold
this command sets the noise gate threshold that will be used when in the manual mode. this represents the level
at which the noise gate will activate.
Command Form : DEVICE PANGT <Channel> <group> [value]
Argument Type Size Values units
Channel Channel 1 see groups and Channels
group group 1 23 (J)
value signed Float 2 -100.00 to 0.00
(null to query in text) dB
PAPOL – Polarity Switch
this command changes audio signal polarity on a power amplifier channel.
Command Form : DEVICE PAPOL <Channel> <group> [value]
Argument Type Size Values units
Channel Channel 1 see groups and Channels
group group 1 23 (J)
value unsigned short 2 0 = normal
1 = reverse
2 = toggle
(null to query in text)
PARST – PA Reset
this command resets the power supplies on an individual power amplifier circuits. There is no query associated
with this command.
Command Form : DEVICE PARST <Channel> <group> [value]
Argument Type Size Values units
Channel Channel 1 see groups and Channels
group group 1 23 (J)
reserved Zero 2 Zero
PASmE – PA Sound Mask Enable
this command enables the sound mask signal on a pa Channel
Command Form : DEVICE PASmE <Channel> <group> [value]
Argument Type Size Values units
Channel Channel 1 see groups and Channels
group group 1 23 (J)
value unsigned short 2 0 = voice mode
1 = Wideband mode
(null to query in text)
PASmL – PA Sound Mask Level
this command selects/reports the sound mask level on a pa channel.
Command Form : DEVICE PASmL <Channel> <group> [amplitude]
Argument Type Size Values units
Channel Channel 1 see groups and Channels
group group 1 23 (J)
amplitude signed short 2 -60.00 – 20.00
(null to query in text) dB