Hardy HI 2151/30WC Single-Scale Controller User Manual
Operation and installation manual
Advertising
Table of contents
Document Outline
- HI 2151 SERIES WEIGHT CONTROLLERS
- REMOTE I/O OPTION
- OPERATION AND INSTALLATION
- MANUAL
- TABLE OF CONTENTS
- TABLE OF ILLUSTRATIONS
- List of Tables
- Chapter 1 - Overview
- Chapter 2 - Installation
- Chapter 3 - Setup
- Chapter 4 - Discrete Transfers
- Chapter 5 - Block Transfers
- About Block Transfers
- Block Read Commands
- Block Read Command Number 1: Full Status and Weight Data
- Block Read Command Number 2: Setpoint Relay Parameter
- Block Read Command Number 3: Instrument Identification and Diagnostics
- Block Read Command Number 4: Read Tare Value
- Block Read Command Number 5: Calibration Parameters
- Block Read Command Number 6: Configuration of Rate-of-Change
- Block Read Command Number 7: BCD Output Configuration
- Block Read Command Number 8: Configuration of Analog Output
- Block Read Command Number 9: Configuration of Standard RS232 Port (HI 2151/20WC Only)
- Block Read Command Number 10: Sticker Value
- Block Read Command Number 11: Auto Zero Tolerance
- Block Read Command Number 12: Integrated Technician
- Block Transfer Read Example
- Block Write Commands
- About Block Write Commands
- Block Write Command Number 51: Activate Scale Functions
- Block Write Command Number 52: Downloading Setpoint Relay Parameters
- Block Write Command Number 53: Send Tare Value
- Block Write Command Number 54: Scale Calibration Action
- Block Write Command Number 55: Calibration Parameters
- Block Write Command Number 56: Configuration of Rate-of-Change
- Block Write Command Number 57: BCD Output Configuration
- Block Write Command Number 58: Configuration of Analog Output
- Block Write Command Number 59: Configuration of Standard RS232 Port
- Block Write Command Number 60: Sticker Value
- Block Write Command Number 61: Auto Zero Tolerance
- Block Write Command Number 62: Waversaver/ Excitation Monitor
- Block Transfer Write Example
- Integer to Floating Point Routine
- Response and Error Codes
- Chapter 6 - Conversion Charts and Formulas