Uploading socketserver – Comtrol PortVision DX User Manual
Page 102
PortVision DX User Guide
Uploading SocketServer
Use this section to upload SocketServer on the DeviceMaster. Technical Support recommends
updating SocketServer before any software installation or configuration to avoid configuration
problems.
Note: Do not attempt to uploadfirmware across a wifi connection.
You can upload one DeviceMaster or several DeviceMasters at a time.
1.
Make sure that you have
downloaded the latest version
.
Note: Although this link goes to the DeviceMaster RTS subdirectory, the firmware for the
DeviceMaster family is the same.
2.
If necessary, disable DeviceMaster NS-Link driver for Windows before uploading the
Bootloader.
a.
Click the Start button and open the Comtrol | DeviceMaster | DeviceMaster
Driver Management Console.
b.
If necessary, click Yes to the User Account Control pop up message.
c.
Right-click the DeviceMaster that you want to disable.
d.
Select Disable.
e.
Click Ok to close the Comtrol Drivers Management Console.
3.
In the Device List pane, use one of the following methods to start the upload firmware
process:
•
Highlight the DeviceMaster or shift-click multiple DeviceMasters and click the
Upload button
•
Right-click the DeviceMaster or shift-click multiple DeviceMasters, click
Advanced, and then Upload Firmware
•
Highlight the DeviceMaster or shift-click multiple DeviceMasters, click Advanced
and then Upload Firmware on the Manage menu
102
Software Settings
- DeviceMaster LT/PRO/RTS/Serial Hub/500