Comtrol PortVision DX - Manual (Page 87)

PortVision DX User Guide
4. If the serial number does not display, you can enter the serial number of the
DeviceMaster in the event that you require it later.
Note: The Device Status field is an informational field that displays the same status
displayed on the Main screen.
5. Select the appropriate Detection Type , local or remote.
6. Click the appropriate IP Mode :
•
Disable IP to run the DeviceMaster using the MAC addressing scheme and disable all
IP communications.
•
DHCP IP to use the DeviceMaster with DHCP. Contact the Network Administrator to
provide the MAC address of the DeviceMaster and ask if you should change the
Subnet Mask, or Default Gateway values.
•
Static IP to program a static IP address and enter the appropriate values (IP address,
subnet mask, and default gateway) for your site.
7. Optionally, change the Bootloader Timeout value.
Note: You must have SocketServer v9.06 or higher for the Bootloader Timeout field to
display.
8. After entering the changes, click Apply Changes.
9. Click Close.
Network Configuration
- DeviceMaster LT/PRO/RTS/Serial Hub/500
87