Comtrol PortVision DX - Manual (Page 86)

PortVision DX User Guide
DeviceMaster (LT, PRO, RTS, Serial Hub, and 500)
Use the following procedure to program network information into a single DeviceMaster at a time.
If necessary, you can program multiple DeviceMasters at the same time.
Note: For initial configuration, the DeviceMaster must be on the same network segment.
1. Highlight the DeviceMaster for which you want to program network information and
access the General tab on the Properties screen using one of these methods:
•
Double-click the DeviceMaster in the Device Tree or Device List.
•
Right-click the DeviceMaster in the Device Tree or Device List and click Properties.
•
Highlight the DeviceMaster in the Device Tree or Device List, click the Properties
button.
•
Highlight the DeviceMaster in the Device Tree or Device List, click the Manage menu,
and then Properties.
2. If necessary, enter the user name and password.
3. Optionally, change the Device Name. The default Device Name is the last three pairs of
numbers from the MAC address. A device name is required.
Note: You cannot edit the MAC Address field, it is automatically populated with the
DeviceMaster MAC address, if it was discovered during a scan.
86 Network Configuration
- DeviceMaster LT/PRO/RTS/Serial Hub/500