Comtrol PortVision DX - Manual (Page 29)

PortVision DX User Guide
Manage Menu Description
• If you click Folder, the Add New Folder pop up opens.
You can Rename, Move, or Delete a Device or Folder using the
Manage menu or Manage pop up menu.
Webpage
(Device List Pane Active)
Opens the default browser and connects to the Comtrol Ethernet
attached product through the IP address to open the default
application, which is the same as clicking the Webpage button on
the Main screen.
Optionally, right-click on a Comtrol Ethernet attached product and
click Webpage from the popup menu.
Telnet/SSH Session
(Device List Pane Active)
Opens a Telnet/SSH session for the selected Comtrol Ethernet
attached product.
Advanced
(Submenu)
Advanced provides access to these options when the Device List
pane is active.
• Reboot or resets the selected Comtrol Ethernet attached
product or Comtrol Ethernet attached products. The network
LEDs on the Comtrol Ethernet attached product flash during
the boot cycle. This option is disabled if Secure Config Mode
is enabled on a
DeviceMaster in SocketServer.
•
Upload Firmware uploads firmware into the selected Comtrol
Ethernet attached product or Comtrol Ethernet attached
products unless Secure Config Mode is enabled on a
DeviceMaster .
If you have not done so, download the latest firmware. It is
recommended that you copy or if necessary, unpackage the
firmware to your hard drive before uploading the firmware to
the Comtrol Ethernet attached product.
• Change Detection Type defines the way that PortVision DX
should communicate with the DeviceMaster.
• LOCAL means that the DeviceMaster is on this local
network segment.
• REMOTE means that the DeviceMaster is not connected
to this segment of the network.
•
Assign IP to Multiple Devices you can use this feature to
assign an IP address or a range of IP addresses to the
selected Comtrol Ethernet attached products.
You must shift-click multiple Comtrol Ethernet attached product
of the same family for this option to be available.
•
Save Device Diagnostics Data is an IO-Link Master option
that saves the diagnostic data collected on the IO-Link Master.
This file is intended for Comtrol Technical Support to diagnose
IO-Link Master problems.
User Interface Overview 29