Ethernet option (for ft-11 only), Electrical connections – Flintec FT-11D User Manual
Page 26
FT-11(D) Technical Manual, Rev. 1.35 November 2010
Page 26 of 52
8.3. Ethernet Option (for FT-11 only)
FT-1x series indicators which are equipped with an Ethernet option can be connected to Ethernet TCP/IP or
Modbus RTU over Ethernet networks as described below.
8.3.1. Electrical
Connections
The pin configuration of the RJ45 Ethernet connector is described below:
Pin no.
Signal
Description
1
TX+
Differential Ethernet transmit data +
2
TX–
Differential Ethernet transmit data –
3
RX+
Differential Ethernet receive data +
4
Not used, terminated
5
Not used, terminated
6
RX–
Differential Ethernet receive data –
7
Not used, terminated
8
Not used, terminated
1
2
1
2
1: Link LED
2 Activity LED
Shield
Chassis
ground
State
Link LED
Activity LED
Off
No link
No Activity
Amber
10 Mbit/s
Half Duplex
Green
100 Mbit/s
Full Duplex
Connection to an Ethernet hub
Cabling is done using a standard
RJ-45 patch cable.
Direct connection to a PC
Cabling is done using a RJ-45
cross over cable.
8.3.2. Setup
There are several setup parameters for the Ethernet network as described below:
Host Name
Device name on the network. Default is “ “
IP Address
The numeric code that identifies all computers that are connected to the internet.
Default is “92.168.16.250”
Local Port
Ethernet connection point of the device. Default is “10001”
Gateway
Network point that acts as an entrance to other networks. Default is “192.168.16.254”
Subnet Mask
Defines a range of IP addresses in a network. Default is “255.255.255.0”
Primary DNS
Primary DNS server IP address
Secondary DNS
Secondary DNS server IP address
DHCP
The Dynamic Host Configuration Protocol provides dynamically allocated IP
addresses to computers on a network, if it is enabled.
Remote
Connection
Automatic connection to any device on the network
Remote IP
IP address of the PC or device which should be connected automatically
Remote Port
Ethernet connection point of the PC or device which should be connected
automatically
Important hint:
During the setup the Ethernet output (weight value and status bits) will not be updated.