Flintec FT-11D - Manual (Page 34)

FT-11(D) Technical Manual, Rev. 1.35 November 2010 Page 34 of 52
[132 X] Input 2
0 = Disabled (factory default) 1 = Zero 2 = Tare
3 = Clear 4 = Print 5 = Key lock
[133 X] Input 3
0 = Disabled (factory default) 1 = Zero 2 = Tare
3 = Clear 4 = Print 5 = Key lock
9.2.3. Entering Setpoints
Press the <SP> key to enter the setpoint memory. The setpoint values will be defined by the <Zero> and
<Tare> keys and confirmed with the <Enter> key. You will advance to the next setpoint. Here you can select
between setpoints via the <
> and <> keys. Quit without saving by pressing the <F> key.
9.3. Binary Output Option
This option adds a 17-bit binary output to the instrument which changes in the value range between “0” and
“131 071” depending on the displayed value and the zeroing input status.
The value of the binary output will change related to the display value as stated in the table below.
BINARY OUTPUT
Condition (On Displayed) Data Negative Error
Over High Low High
Under High High High
ADC Out High Low High
Weight indication Binary X Low
The pin configuration of the D25 female binary connector is given below.
Pin no. Connection Definition
1 24V DC POWER SUPPLY
14-2 GND POWER SUPPLY
15 TEST INPUT
3 D0 2
0
16 D1 2 1
4 D2 2
2
17 D3 2
3
5 D4 2
4
18 D5 2
5
6 D6 2 6
19 D7 2
7
7 D8 2
8
20 D9 2
9
8 D10 2 10
21 D11 2
11
9 D12 2
12
22 D13 2
13
10 D14 2
14
23 D15 2 15
11 D16 2
16
24 Strobe 1 = Data Ready
12 Zero Input
25 Error Output
13 negative Output
D25 body Schirm
“Data Ready” means that the weight data can
be read from the output.
If the output value is low, a wrong reading of
the weight value is probable.
If you apply a test input, the weight data
output will be interrupted and all outputs will
be activated sequentially during the test input
is active.
Outputs are PNP open collector and common
is ground.
The binary output card has to be supplied with
24 V DC ( max. 28 V DC ), maximum current
consumption can be up to 200 mA.