Flintec FT-11D - Manual (Page 51)

FT-11(D) Technical Manual, Rev. 1.35 November 2010 Page 51 of 52
Parameter Factory defaults FT-11 FT-11D
2-- Scale Parameters x x
20- Set up x x
200 Approved 0 = No x x
201 Increased indication 0 = With x10 key x x
202 Power on zero 2 = ± %10 x x
203 Zero with key 1 = ± %2 x x
204 Auto zero tracking 0 = Disable x x
205 Tare 1 = With Tare Key x x
206 Motion detector 1 = ± 0,5e x x
207 Tilt switch 0 = Disable x
208 Stability time 0.0 s x
21- Scale Build x x
210 Scale Type 0 = Single Range x x
211 Capacity 1 / d1 x x
212 Capacity (2) / d(2) 6 kg / 1 g x x
22- DLC Configuration Block x
220 DLC Type 0 = Flintec RC3D x
221 Quantity of DLC 1 x
222 DLC Address x
3-- Calibration / Adjustment x x
30- Calibration x x
300 Gravity x
301 Calibration x x
31- Adjustment x x
310 Zero adjustment x x
311 Span adjustment x x
312 Span adjustment under load x
313 ecal x x
32- Eccentricity Adjustment x
320 Adjustment Method 0 = independend DLC x
321 Auto Adjustment x
322 Manual Adjustment x
323 Temporarily set constants to “1” 0 = normal operation x
4-- Analogue Output x
40- Signal Selection x
400 Analogue Output Signal Type x
41- Zero Adjustment x
410 Coarse Zero Adjustment x
411 Fine Zero Adjustment x
42- Span Adjustment x
420 Coarse Span Adjustment x
421 Fine Span Adjustment x
8-- Metrological Data x x
80- Legal Metrology x x
800 Calibration counter x x
801 Alibi memory x x
802 Calling a record x x
803 Print Alibi memory x x
804 Alibi memory information x x
9-- Diagnostics x x
90- Tests x x
900 Key Pad test x x
901 Serial interface 1 test x x
902 Digital input test x x
904 mV indication x
905 DLC internal count x
91- Serial numbers x x
910 FT-1x serial no. x x
911 Option 1 serial no. (if installed) x x
912 Option 2 serial no. (if installed) x x
913 Option 3 serial no. (if installed) x x
97- Calibration coefficients x x
97X Calibration coefficients x x
99- Print Parameters x x
990 All parameters x x
991 Load default parameters x x