Futaba 3PKS - Manual (Page 100)

100
F
u
nction
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* When the direct call button is set,
the setup screen is also called by the
following method:
HRS ESC Setup "MCSET"
This screen does not appear except when the DSC
cord is connected or set to ON by display switch.
HRS ESC Setup "MCSET"
This function is used only when using an ESC like that shown below with a high re-
sponse system (HRS System). This function is not used when using a Futaba ESC.
The frame rate of the transmitter output signal at setup may be counted and the
setup mode forcefully ended after a fixed time has elapsed, depending on the com-
mercially available ECS. If such an ECS is used with the high response system, the
setup time will be substantially shortened and ECS setup may become difficult.
When you have an FM receiver or PCM receive, only amp setup is possible in the
PPM or PCM mode.
When using this function to make adjustments, the ECS must be directly connected to
the transmitter. Also, the following connection cords are necessary.
- Two-way cord (Must be bought separately.)
- DSC cord (Supplied with set.)