Futaba 3PKS - Manual (Page 88)

88
F
u
nction
Timer Function "TIMER"
(Preparation)
Select the setting item "TYPE" by (JOG) button up or down
operation. Press the (+) or (-) button and select "NAVIGATE".
1
(Alarm time setting)
Select the setting item "ALRM"
by (JOG) button up, down, left, or
right operation and set the alarm
time with the (+) and (-) buttons.
(Pre alarm time setting)
Select the setting item "PRAL" by (JOG) button up, down, left, or right
operation and set the pre alarm time with the (+) and (-) buttons.
(Lap navigation time setting)
Select the setting item "NAVI" by (JOG) button up, down, left,
or right operation and set the lap navigation alarm (target)
time with the (+) and (-) buttons.
2
(Timer start/navigation restart operation)
When the switch ("LAP START") assigned by function select
switch function is pressed, the
timer starts.
- Linking only start to the throt-
tle trigger
Select the setting item "RST" by (JOG) button up, down, left,
or right operation and press the (+) and (-) buttons simultane-
ously for about 1 second. The set beeps and the status dis-
plays changes from "RST" to blinking "RDY" and the set enters
the trigger operation ready state. When the trigger is operated
at the forward side, the timer starts. (Status display "RUN")
- When your own lap time is less than the target time and the lap counts
overlap, the lap navigation alarm timing is too big. The alarm timing can
be corrected by pressing the switch ("LAP START") during measure-
ment.
3
(Timer stop/reset operation)
When the switch ("LAP RE-
SET") assigned by function se-
lect switch function is pressed,
the timer stops. Reset the
timer by pressing the "LAP
RESET" switch.
When a switch is not assigned, select the status display
("RUN" or "RDY") by (JOG) button up or down operation and
press the (+) and (-) buttons simultaneously for about 1 sec-
ond. The set beeps and the timer resets. (Does not pause)
Using the navigate timer
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons
simultaneously (approx. 1 sec)
to return to the initial screen.
Alarm time (ALRM)
OFF, 1 ~ 99 m
Initial value: 8 m
Prealarm time (PRAL)
OFF, 1 ~ 30 s
Initial value: OFF
Navi alarm time (NAVI)
OFF, 1 ~ 30 s
Initial value: 3 s
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
STP : Timer stopped
Switches
LAP START :start/navi restart
LAP RESET :stop/reset
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
STP : Timer stopped