Futaba 3PKS - Manual (Page 28)

0 1
2
3
45 6
7
8
9 0 1
2
3
45 6
7
8
9
Channel No.
tens digit
Channel No.
units digit
ｉ Caution
28
B
e
fo
re
Using
Synthesizer receiver R303FHS
Set the frequency band with the power switch in the OFF position.
Frequency band setting
1
Using the accessory mini screwdriver, set the left side
dial to the tens digit of the band No. you want to set.
2
Next, set the right side dial to the units digit of the
band No. you want to set.
3
Confirm that the transmitter band matches the band
above, then set the power switches to ON in transmit-
ter and receiver order.
R303FHS operation note
When the power is turned on, whether the receiver is in the HRS or PPM mode is judged and the R303FHs
operates in that mode until the power is turned off. When the transmitter mode was changed, operation be-
comes possible when the receiver power is turned on again. When the frequency band was changed, recep-
tion on the new frequency band becomes possible when the receiver power is turned on again.
ｅ When using the T3PKs in the high response system (HRS) mode, always use it under the follow-
ing conditions:
Receiver: R203HF, R303FHS or other high response system (HRS) compatible receiver
Servos : 6V Futaba digital servo
Battery : 6V NiCd battery
Transmitter mode : HRS mode (See p.42 for setting method.)
If the conditions are different, control is impossible.
And Fail Safe Unit (FSU) is not available.
ｅ When using analog servos, always switch the T3PKS to the PPM mode.
Receiver: R113iP(PCM), R303FHS(PPM)
Transmitter mode : PPM or PCM mode (See p.42 for setting method.)
The system will not operate normally in other modes. Such operation will cause servo trouble.
ｅ Always use only genuine Futaba transmitters, receivers, servos, FET amps (electronic speed
controls),Nicad batteries and other optional accessories.
Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the parts speci-
fied in the instruction manual and catalog.
For the receiver, servos, and other connections, see page 29. For the DSC cord (option)
connections, see page 112.