Futaba 3PKS - Manual (Page 71)

71
F
u
nction
Brake Mixing "BRAKE"
3rd channel brake-A.B.S : ON
1
(Function ON/OFF)
Select the setting item "MODE" by (JOG) button up, down,
left or right operation. Set the function to the active state by
pressing the (+) or (-) button.
"INH(OFF)" :Function OFF
"ACT(ON)"
:Function ON
2
(3rd channel brake rate)
Select setup item "RATE" by (JOG) button up, down, left or
right operation, and use the (+) and (-) buttons to adjust the
3rd channel brake rate amount.
3
(3rd channel brake-EXP)
Select setup item "EXP" by (JOG) button up, down, left or
right operation. When you want to quicken the rise, use the (+)
button to adjust the + side and when you want to make the
rise milder, use the (-) button to adjust the - side.
4
(Delay amount setup)
Select setup item "DLY" by (JOG) button up, down, left or
right operation, and use the (+) and (-) button to adjust the
delay amount.
"0" :No delay
"100" :Maximum delay amount
- This system sets either the "F" side or "R" side delay.
5
(3rd channel brake-A.B.S ON/OFF)
Select setup item "CH3ABS"
by (JOG) button up, down,
left or right operation. Set the
function to the "ACT" state by
pressing the (+) or (-) button.
6
(3rd channel brake-A.B.S return amount adjustment)
Select setup item "ABP" by (JOG) button up, down, left or
right operation, and use the (+) and (-) buttons to adjust the
return amount.
7
(3rd channel brake-A.B.S delay amount setup)
Select setup item "DLY" by (JOG) button up, down, left or
right operation, and use the (+) and (-) buttons to adjust the
delay amount.
8
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
Brake mixing adjustment
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
3rd channel Brake rate (RATE)
0 ~ 100
Initial value:100
3rd channel brake EXP rate
(EXP)
-100 ~ 0 ~ +100%
Initial value:0
Delay amount (DLY)
F100~F1, 0 ,R1~R100
Delay amount for foward(F) or
rear(R) side can be set.
Initial value:0
Brake return amount (ABP)
0 ~ 50 ~ 100
Initial value; 50
"0" :No return
"50" :Return to the 50% position of
the brake operation amount
"100" :Return to the neutral position.
Delay amount (DLY)
0 ~ 100
Initial value; 0
"0" :A.B.S. function performed
without any delay
"50" :A.B.S function performed
after an approximate 0.7
sec delay.
"100" :A.B.S. function performed
after an approximate 1.7
secs delay.
Setup item selection
- Select by (JOG) button up,
down, left or right operation.
Function ON/OFF (MDE)
INH(OFF), ACT(ON), ACT(OFF)
Function ON/OFF (CH3ABS)
INH(OFF), ACT(ON), ACT(OFF)