Futaba 3PKS - Manual (Page 22)

22
B
e
fo
re
Using
Total timer display (H:M)
Battery voltage display
Steering trim display
Throttle trim display
DL1
DL2
DL3
DT1
DT2
DT3
User name display
When the (END) button is held down for 1 second or longer at the initial screen, the
Futaba logo and user name are displayed for about 2 seconds.
Edit button lock display
Trim/dial lock display
Power switch turned on
Beep confirmation sound is generated and the
initial screen shown below appears.
Display when power switch turned on
*Function names and rate
assigned to dials are dis-
played.
* D i s p l a y m o d e c a n b e
changed by using the SYS-
TEM function. (See pge 98)
Model name (10 characters)
Edit button lock and trim/dial lock
T3PKS setup and operation by edit button (p.15) and digital trim DT1, DT2, and DT3
and dials DL1, DL2, and DL3 can be prohibited.
Setting
1
Edit button lock; When the (+) button is pressed for about 1 second at the initial screen,
a confirmation beep is generated and the edit button lock display appears on the
screen.
Trim/dial lock; When the (-) button is pressed for about 1 second at the initial screen,
a confirmation beep is generated and the trim/dial lock display appears on the
screen.
Clearing
1
Edit button lock and trim/dial lock can be cleared in the initial screen state by the same
method as setting described above. (The edit button lock display or trim/dial lock
display disappears from the screen.)
Displays whether or not a memory
module is inserted. When a memory
module is inserted, "DPAC" is dis-
played. "BLHT" is displayed when back-
lighting is ON.
When radio waves are being
emitted, "RF" is displayed. When
radio waves are not being emitted
when turned on by display switch
and when the DSC function is
used, "DISP" is displayed. Displays whether or not a
memory module is inserted.
When a memory module is
inserted, "DPAC" is displayed.