Futaba 3PKS - Manual (Page 79)

SW3
SW1
SW2
Abbreviation used
on setup screen
Function name, etc
AT-START Start function / Engine cut
TH-SPEED Throttle speed
A.B.S.CH2 A.B.S function (2CH)
A.B.S.CH3 A.B.S function (3CH)
D/R 2ND 2nd dual rate
IDLE-UP Idle up
PROG MIX1 Program mixing 1
PROG MIX2 Program mixing 2
CH3 channel 3
LAP STAR Timer function start (SW3 not possible)
LAP RESET Timer function reset (SW3 not possible)
OFF Not used
Settable functions (SW1/SW2/SW3)
79
F
u
nction
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* When the direct call button is set,
the setup screen is also called by the
following method:
Function Select Switch "SWTCH"
Function Select Switch "SWTCH"
Function selection
Direction of operation setting
(NOR/ALT)
1
(Setting SW selection)
Select the item you want to set by (JOG) button up, down,
left, or right operation.
2
(To select or change a function for SW)
Select one of the functions for "SW" by pressing (+) or (-) button.
(To change the operation mode)
Select othe operation mode for "SW" by pressing (+) or (-) button.
3
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
Function select switch setup
This function allows selection of the function to be performed by the switches
(SW1/SW2/SW3) and setting of the direction,
etc. of operation.
-The table to the right shows the functions that
can be assigned to each push switch.
-SW1 and SW2 can be made alter nate op-
eration (ON/OFF switched each time SW
pressed).(NOR/ALT)
-The direction of operation of SW3 can be
reversed.(NOR/REV)
•Select the setting item by button
* blinks at the current setup item.
Setup buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons
simultaneously (approx. 1 sec)
to return to the initial screen.
Initial value:
SW1,SW2,SW3 :"OFF", "NOR"
Setup item selection
- Select by (JOG) button up,
down, left or right operation.