Futaba 3PKS - Manual (Page 65)

With A.B.S.
Without A.B.S.
65
F
u
nction
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* When the direct call button is set,
the setup screen is also called by the
following method:
•Select the setting item by
button
* b l i n k s a t t h e c u r r e n t
setup item.
A.B.S Function "A.B.S"
- When the brakes are applied, the throttle servo will pulse
intermittently. This will have the same effect as pumping
the brakes in a full size car.
- The brake return amount, pulse cycle, and brake duty can
be adjusted.
- The region over which the ABS is effective can be set ac-
cording to the steering operation. (Mixing function)
Operation
During ABS operation, the LED blinks, (If LED color is not selected as off).
display also appears on the initial screen and menu screen.
Operation display
Setup items
ABP
: Brake return amount
DLY : Delay amount
CYC : Cycle speed
MODE : Function ON/Off
TGP : Operation point
DTY : Cycle duty ratio
STM : Steering mixing
A bar graph that shows the
o p e ra t i n g p o s i t i o n o f t h e
throttle appears. During set-
up, A.B.S function operation
can be checked at this bar
graph.
When brake operation enters
the set range, " " is displayed in
front of the number.
ATL (brake) rate can be confirmed
on the A.B.S function screen.
When "CUT OFF", which prohibits trigger brake side operation, was set in the boat
mode (p.72), the ABS function will not actually operate even if set.
When "TRG-BRK" was set to "CUT OFF" by boat mode function
A.B.S Function "A.B.S" (Throttle system)
When the brakes are applied while cornering with a 4 Wheel
Drive or other type of vehicle, understeer may occur. The gen-
eration of understeer can be eliminated and corners can be
smoothly cleared by using this function.