Futaba 10CG 2.4GHz - Manual (Page 104)

104
HOVERING ADJUSTMENTS (HOV-THR and HOV-PIT):
+RYHULQJWKURWWOHDQGKRYHULQJSLWFKDUH¿QHWXQLQJDGMXVWPHQWVIRUWKHWKURWWOHDQGFROOHFWLYHSLWFKFXUYHVLQGLYLGXDOO\
DIIHFWLQJSHUIRUPDQFHRQO\DURXQGWKHFHQWHUSRLQWDQGRQO\LQWKHQRUPDOFRQGLWLRQ7KH\DOORZLQÀLJKWWZHDNLQJRIWKH
curves for ideal setup.
Adjustability:
‡5RWRUVSHHGFKDQJHVFDXVHGE\WHPSKXPLGLW\DOWLWXGHRURWKHUFKDQJHVLQÀ\LQJFRQGLWLRQVDUHHDVLO\DFFRPPRGDWHG
• Both adjustments may be inhibited if not desired.
• Both adjustments may also be set to NULL, temporarily turning off the knob but maintaining the last memorized setting.
• Adjustments may be memorized and then the knobs returned to center point to use that amount of adjustment. Allows
easy use of the trimming knobs for multiple models. (Note that when memorization is repeated with the knob offset from
center, the trim value accumulates.)
• Adjustments are quickly reset to the initial value by turning the dial until the trim reads 0%, memorizing, then returning
the knob to its center position.
• Note that all functions, including these, assume the model hovers at half stick.
• Available in normal (NORM
RUQRUPDOLGOHXS NORM/IDL1) condition only.
GOAL of EXAMPLE: STEPS: INPUTS:
Fine-tune hovering with the hovering
adjustments. Remember these affect
only the hovering (normal) condition.
Adjust throttle and collective pitch
curves until the model hovers nicely. In
ÀLJKWDGMXVWFROOHFWLYHSLWFKDQGWKURWWOH
curves near hover point independently
with HOV-THR and HOV-PIT knobs.
6WRUHQHZVHWWLQJVDIWHUÀLJKW
Open the HOV-THR function. for 1 second. (If BASIC, again.)
C to HOV-THR.
Optional: change which knob adjusts
each hovering curve. NULL locks in
curve in last stored position. C to VR.
to desired knob and direction.
Store the current dial settings prior to
selecting another model. C to RATE.
for one second to store.
or VR(C) to center.
Close.
Open the HOV-PIT function. C to HOV-PIT.
Store the current dial settings prior to
selecting another model. C to RATE.
for one second to store.
or VR(A) to center.
Close.
Where next? THR-HOLD : see p. 99.
Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing
(TH-CURVE, PIT-CURVE, REVO. MIX) for idle-ups: see p. 101.
D/R
,EXP: see p. 42.