Futaba 10CG 2.4GHz - Manual (Page 96)

96
Throttle Mixing (THROTTLE MIX):
This function can be set for each flight condition, and is used to correct the
tendency of the model to change altitude when the rotor is tilted by aileron,
elevator, and rudder controls.
Adjustability:
‡0L[LQJPD\EHVHWIURPWRIRUHDFKÀLJKWFRQGLWLRQ
GOAL of EXAMPLE: STEPS: INPUTS:
Correct the tendency of the model to
change altitude. Open THROTTLE MIX function. for 1 second. (If BASIC, again.)
to 2nd page of ADVANCE menu.
C to THROTTLE MIX.
Activate the function. C to MIX to ON.
Adjust the rate.
Ex: IDL1 (AIL to TH) 10% C to IDL1 (AIL to TH) to 10%.
Repeat as needed.
Close the menu.
Where next? HI/LOW-PIT : see p. 105.
GOVERNOR set up: see p. 108.
Swash Ring (SWASH RING OLPLWVWKHVZDVKSODWHWUDYHOWRD¿[HGUDQJH
This function limits the swash travel to prevent damaging the swash linkage
by simultaneous operation of the ailerons and elevators. It is effective in 3D
aerobatics which use a large amount of travel.
GOAL of EXAMPLE: STEPS: INPUTS:
To prevent damaging the swash linkage
b y s i m u l t a n e o u s o p e r a t i o n o f t h e
ailerons and elevators, set the limit
point where swash throw stops.
*Adjust the rate at the maximum swash
tilt by simultaneous operation of the
ailerons and elevators
Open SWASH RING function. for 1 second. (If BASIC, again.)
to 2nd page of ADVANCE menu.
C to SWASH RING.
Activate the function. C to MIX to ON.
Adjust the rate.
Ex: 90% C to RATE to 90%.
Close the menu.
• S w a s h t r a v e l b y s i m u l t a n e o u s o p e r a t i o n o f
the ailerons and elevators is limited within the
circle(SWASH RING rate).
Adjustability:
• Initial value: 100%.
• Adjustment range: 0 to 200%.
Aileron operation
Elevator operation