Futaba 10CG 2.4GHz - Manual (Page 20)

20
Operation Mode Select (R6008HS/R6014HS):
R6014HS
R6008HS
LED Link/Mode
Switch
LED
Link/Mode
Switch
The operation mode is on "Normal mode" from factory shipping. To change the mode, please adhere to the following
steps:
0 to 1 sec. More than 1 sec.
0 sec. 1 sec.
Press and Hold time
Turn on the receiver.
No function
Showing the CURRENT
mode with blink.
Red Blink = Normal
Green/Red Blink =
High Speed
Solid as the mode changed.
Red Solid = Normal
Green/Red Solid = High
Speed
(Become Red after one (1)
second)
㧔Function㧕
To change the mode between
Normal and High Speed
㧔LED Status㧕
1. Turn off the receiver.
2. Press and hold the Link/Mode switch and turn on the receiver.
Keep holding the switch for more than one(1) second. The LED
EHJLQVÀDVKLQJWRLQGLFDWHWKHFXUUHQWVWDWXV
3. Release the switch.
4. Turn off the receiver.
By doing so, the receiver will change modes.
Please check the operation mode by observing the LED when turning on the receiver. If possible ensure that there's no
FASST transmitter in operation near the receiver.
When the receiver is turned on:
•Red when on "Normal mode"
•Green and Red (makes Orange) when on "High Speed mode". (After two(2) seconds, change to Red.)
If there are some FASST transmitters turned on near the receiver, the LED may show the above status for a brief moment
before changing to the status indication as shown in the "LED indication" table above.