Futaba 10CG 2.4GHz User Manual
Page 62
62
ELEV-FLAP
mixing (ACRO
GLID):
ELEV-FLAP
PL[LQJLVWKH¿UVWSUHSURJUDPPHGPL[ZH OOFRYHU7KLVPL[PDNHV
WKH ÀDSV GURS RU ULVH ZKHQHYHU WKH ELEVATOR STICK is moved. It is most
commonly used to make tighter pylon turns or squarer corners in maneuvers. In
PRVWFDVHVWKHÀDSVGURRS DUHORZHUHG ZKHQXSHOHYDWRULVFRPPDQGHG
Adjustability:
• Rate
IXOO XS ÀDS WR IXOO GRZQ ÀDS ZLWK D GHIDXOW RI
RQHKDOIRIWKHÀDSUDQJHLVDFKLHYHG when the ELEVATOR STICK is pulled
to provide full up elevator.)
• Switch: fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up
LOGIC SW
: See p. 38.
*IF you set it to NULL, the mix does not work. (ACRO)
•Range (GLID): The range that mixing does not work near neutral of an elevator
stick can be set up.
Hold the stick to the desired point (upper or lower side) , then press DIAL and
hold one second to set the range.
• Condition (GLID): Separate ELEV-FLAP settings for each condition can be set.
(ACRO)
(GLID)
GOAL of EXAMPLE:
STEPS:
INPUTS:
Activate ELEV-FLAP mixing. Adjust flap
travel to 0%
ÀDSVZLWKQHJDWLYHHOHYDWRU
(push) and 45% flaps with positive
elevator.
Open the ELEV-FLAP function.
for 1 second.
(If BASIC,
again.)
C
to ELEV-FLAP.
Activate the function.
C
to MIX.
to ACT.
Adjust the travels as needed.
(Ex: 0%,to 45%.)
C
to RATE.
ELEVATOR STICK.
to 0%.
ELEVATOR STICK.
to 45%.
Close menu.
Where next?
$GMXVWÀDSHURQV
ÀDSWUDYHODYDLODEOH FLAPERON): see p. 52.
Set up AIRBRAKE
FURZEXWWHUÀ\ VHHS
Set up programmable mixes (ex: FLAP-ELEVATOR): see p. 68.
View additional setups on the internet: www.futaba-rc.com\faq\.