Futaba 10CG 2.4GHz - Manual (Page 32)

32
MODEL NAME : assigns a name to the current model memory. By giving each model a name that is immediately recognizable,
\RXFDQTXLFNO\VHOHFWWKHFRUUHFWPRGHODQGPLQLPL]HWKHFKDQFHRIÀ\LQJWKHZURQJPRGHOPHPRU\ZKLFKFRXOGOHDGWR
a crash.
Adjustability and values:
• Up to 10 characters long.
• Each character may be a letter, number, blank, or a symbol.
• The default names assigned by the factory are in MODEL-xxxx format
(MODEL-0001 IRU¿UVWPRGHOPHPRU\HWF 
NOTE: When you COPY one model memory over another, everything is copied, including the model's name. Similarly, if
you change MODEL TYPE or do a MODEL RESET, the entire memory is reset, including MODEL NAME
6RWKH¿UVWWKLQJ\RXZLOO
want to do after you COPY a model, change its type, or start from scratch, is rename the new copy to avoid confusion.
GOAL of EXAMPLE: STEPS: INPUTS:
Name model 3 “Cap-232_” (where the
underline represents a blank space.) Open MODEL submenu. for 1 second. (If ADVANCE, again.)
C to MODEL.
Confirm you are currently using the
proper model memory. (Ex: 3) If SELECT does not indicate 3,
perform MODEL SELECT, p. 25.
G o t o N A M E a n d c h a n g e t h e f i r s t
character. (Ex: M to C) C to M to C.
Choose the next character to change. C
Repeat the prior steps to complete
naming the model. to a (note: lower case is available)
Repeat.
Close.
Where next? Change the MODEL TYPE to glider or helicopter: see p. 34.
Change modulation [2.4G-10CH or 2.4G-7CH]: see p. 35.
Utilize servo REVERSE: see p. 38.
Adjust servo travel with END POINT: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDO D/R,EXP): see p. 42.