Futaba 10CG 2.4GHz - Manual (Page 81)

81
AILE RUDD(GLID):
Adjustability:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron (rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up LOGIC SW: See p. 38.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
positions of the same SWITCH.
• Condition: The separate AILE RUDDVHWWLQJVIRUHDFKÀLJKWFRQGLWLRQFDQEHVHW
GOAL of EXAMPLE: STEPS: INPUTS:
([  58''ĺ$,/(  QR VZLWFK
corrects roll coupling. Open AILE RUDD mix submenu. for 1 second. (If BASIC, again.)
to 2nd page of menu.
C to AILE RUDD.
Select the mixing mode. C to MODE. to RUDD ĺAILE
Activate the function. C to MIX to ON.
Set the rate. (Ex: 100% each way) C to FLP1.
RUDDER STICK. to +25%.
RUDDER STICK. to +25%.
Repeat as needed.
Close.
Where next? ELEV-FLAP mixing. See p. 62.
BUTTERFLY . See p. 63.
Use a mix to OFFSET WKHÀDSVDVHWGLVWDQFHRQDVSHFL¿HGVZLWFK VHHS
View additional model setups on the internet: www.futaba-rc.com\faq\
You can select a pre-programed mix which is used to mix the rudders with
aileron operation or the ailerons with rudder operation.
Aileron-to-rudder mix (AILE
ĺRUDD): automatically creates a "coordinated turn".
Rudder -to-aileron mix (RUDD ĺAILE): used to counterract undesirable roll (roll
coupling) that happens with rudder input, especially in knife-edge.