Futaba 10CG 2.4GHz - Manual (Page 51)

51
ACRO ADVANCE MENU FUNCTIONS:
Aircraft wing types (ACRO GLID):
There are 3 basic wing types in aircraft models:
• Simple. Model uses one aileron servo (or multiple servos on a Y-harness into a single receiver channel) and has a tail.
This is the default setup and requires no specialized wing programming.
• Twin Aileron Servos. Model uses 2 aileron servos and has a tail. see Twin Aileron Servos.
• Tail-less model (flying wing). Model uses 2 wing servos working together to create both roll and pitch control. see
ELEVON .
Twin Aileron Servos (with a tail) (ACRO GLID): Many current generation models use two aileron servos, plugged into two
VHSDUDWHUHFHLYHUFKDQQHOV ,I\RXUPRGHOLVDÀ\LQJZLQJZLWKRXWVHSDUDWHHOHYDWRUVVHHELEVON, p. 56.)
%HQH¿WV 
• Ability to adjust each servo's center and end points for perfectly matched travel.
• Redundancy, for example in case of a servo failure or mid-air collision.
• Ease of assembly and more torque per surface by not requiring torque rods for a single servo to drive 2 surfaces.
‡+DYLQJPRUHXSDLOHURQWUDYHOWKDQGRZQWUDYHOIRUVWUDLJKWHUUROOVDLOHURQGLIIHUHQWLDO VHHJORVVDU\IRUGH¿QLWLRQ 
‡8VLQJWKHWZRDLOHURQVQRWRQO\DVDLOHURQVEXWDOVRDVÀDSVLQZKLFKFDVHWKH\DUHFDOOHGÀDSHURQV
• Set a negative percentage to reverse the operation of one of the servos.
Options:
• FLAPERON:
•Uses CH6 for the second servo.
‡$OORZVÀDSDFWLRQDVZHOODVDLOHURQDFWLRQIURPWKHDLOHURQV
•Provides FLAP-TRIM
IXQFWLRQWRDGMXVWWKHQHXWUDOSRLQWRIWKHÀDSHURQVIRUOHYHOÀLJKW
•Also allows aileron differential in its own programming (instead of activating AIL-DIFF).
• Aileron Differential (AIL-DIFF):
•Uses CH7 for the 2nd servo.
‡/HDYHV&+ &+IUHHIRUÀDSRSHUDWLRQVXFKDVÀDSHURQDQGÀDSDFWLRQWRJHWKHULQAIRBRAKE. (see p. 63).
•Allows for more up aileron travel than down for straighter rolls.
You will need to choose either of FLAPERON or AIL-DIFF for your model's setup. If you need the ailerons to also operate as
ÀDSV\RXZLOOPRVWOLNHO\ZDQWWRXVHFLAPERON,I\RXUPRGHOKDVDLOHURQVHUYRVDQGÀDSVWKHQAIL-DIFF is probably the
easiest choice. (For details on setting up a complex aerobatic plane, such as one with 4 wing servos using full span ailerons
DQGIXOOVSDQÀDSVDVZHOODVAIRBRAKEFURZDQGRWKHUIHDWXUHVSOHDVHYLVLWRXU)$4DWZZZIXWDEDUFFRP?IDT?0DQ\
other setup examples are also available at this site.)
NOTE: Only one of the three wing-type functions (FLAPERON, AIL-DIFF, and ELEVON) can be used at a time. All three
IXQFWLRQVFDQQRWEHDFWLYDWHGVLPXOWDQHRXVO\7RDFWLYDWHDGLIIHUHQWZLQJW\SHWKH¿UVWPXVWEHGHDFWLYDWHG
GOAL of EXAMPLE: STEPS: INPUTS:
Deactivate FLAPERON so that AIL-DIFF or
ELEVON
can be activated.
Open the FLAPERON function. for 1 second. (If BASIC, again.)
C to FLAPERON.
Deactivate the function. C to MIX. to INH.
Close function.
Where next? Set up AILE-DIFF (see p. 54) or ELEVON (see p. 56).