Futaba 10CG 2.4GHz - Manual (Page 71)

71
CURVE PROGRAMMABLE MIXES (PROG.MIX5-8)(HELI: PROG.MIX5-6 ):
Your 10CG’s ACRO GLID programs contain four separate curve programmable mixes. HELI contains two. There are a variety
RIUHDVRQV\RXPLJKWZDQWFXUYHPL[HV)RUH[DPSOHZKHQDOLQHDUPL[GRHVQ¶W¿W\RXUQHHGVDORQJWKHZKROHUDQJH2QH
pre-programmed curve mix is the THROTTLE-NEEDLE function. This curve is adjustable at 5 points, allowing you to adjust
the motor’s tuning at 5 points along its RPM range.
One programmable curve mix defaults to RUDDER-AILERON. A linear mix that keeps the model from rolling in knife-edge is
SUREDEO\WRRPXFKDLOHURQZKHQUXGGHULVDSSOLHGLQOHYHOÀLJKW&UHDWHDFXUYHPL[DQGVHWDOOSRLQWVWRPDWFKWKHOLQHDU
mix. Inhibit the linear mix, then adjust the curve to get the right response all along the rudder channel’s travel.
$GMXVWDELOLW\ IRUGHWDLOHGGH¿QLWLRQVVHH/LQHDU3URJUDPPDEOH0L[HVDQG*ORVVDU\
• ACRO
GLID Defaults: The 4 programmable curve mixes default to the most frequent choices, but can be set to any channel.
• PROG.MIX5 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-elev.)
• PROG.MIX6 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-elev.)
• PROG.MIX7 rudder-to-elevator for pitch coupling compensation (GLID mixes default to elevator-to-airbrake.)
• PROG.MIX8 rudder-to-elevator for pitch coupling compensation (GLID mixes default to elevator-to-airbrake.)
• HELI Defaults:
• PROG.MIX5 aileron-to-elevator for coordinated turns
• PROG.MIX6 aileron-to-elevator for coordinated turns
• Master: The controlling channel can only be a channel. Cannot be OFFSET or dial.
• Trim: not available in curve mixes.
• Offset: not available in curve mixes.