Futaba 10CG 2.4GHz User Manual
Page 67
67
Throttle curve (THR-CURVE)(ACRO):
This function adjust the throttle operation curve for optimum engine response to
throttle stick movement.
NOTE: If the throttle EXP function is activated, you can not use THR-CURVE
function simultaneously.
Adjustability:
• Separate curves for each switch position are available.
• Moving and deleting the curve point: The curve point (-stk-) can be moved to the left or right by turning the DIAL (up to
LQIURQWRIWKHDGMRLQLQJSRLQW DQGGHOHWHGUHWXUQHGE\SUHVVLQJWKHDIAL for one second alternately.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Base point: Adjust base point of throttle
curve until engine idles reliably.
-out-
: output, servo position.
-stk-
: curve point, stick position.
Open the THR-CURVE function.
for 1 second.
(If BASIC,
again.)
C
to THR-CURVE.
Activate the function.
C
to MIX.
to ON.
$GMXVWWKH¿UVWSRLQW
C
to point 1 (-out-).
to desired
throttle servo position.
Optional: Assign the switch.
C
to SW.
to desired switch.
Optional: Move the curve point.
(Ex: point 3)
C
to point 3 (-stk-).
to desired
curve point to move to left or right.
Optional: Delete the curve point.
And return the curve point.
(Ex: point 3)
C
to point 3 (-stk-).
for one
second to delete the curve point.
C
to point 3 (-stk-).
for one
second to return.
Next point:
Adjust the next point.
Repeat as needed.
Close.