Futaba 10CG 2.4GHz User Manual
Page 77
77
GOAL of EXAMPLE:
STEPS:
INPUTS:
Adjust travels as needed to match
model’s recommended throws (usually
listed as high rates).P. 39.
In the BASIC menu, choose END POINT.
C
to END POINT.
to choose END POINT.
Adjust the servos’ end points.
([ ÀDSVHUYR
Close the function.
C
to FLAP.
VR(A)
until travel as desired.
VR(A). Repeat as needed.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDO
(D/R,EXP)
P. 42.
(Note that in the middle of the left
side of the screen is the name of the
channel and the SWITCH position
you are adjusting. Two or even three
rates maybe set per channel by simply
choosing the desired SWITCH and
programming percentages with the
SWITCH
LQHDFKRILWVSRVLWLRQV
Choose D/R,EXP.
C
to D/R,EXP.
to choose D/R,EXP.
Choose the desired control, and set
the first (Ex: high) rate throws and
exponential.
C
to CH>.
to choose CH>2 (elevator).
A to up position.
[Note screen reads ELEV
(UP)
]
C
to D/R.
ELEVATOR STICK.
to set.
ELEVATOR STICK.
to set.
(Normally the same for both directions.)
C
to EXP.
ELEVATOR STICK.
to set.
ELEVATOR STICK.
to set.
Set the second (low) rate throws and
exponential.
C
to D/R.
A to down position.
Repeat above to set low rate.
Optional: change dual rate SWITCH
assignment. Ex: elevator to SWITCH G
with 3 positions.
C
to SW.
to G.
G to center position.
Repeat steps above to set 3rd rate.
0RYHÀDSFRQWUROIURPWKH95 $ GLDO
to the left slider [VR(D)]. (AUX-CH)
p. 46.
In the BASIC menu, open AUX-CH.
C
to AUX-CH.
to choose AUX-CH.
Choose CH6
ÀDS
Change primary control to VR(D).
Change other channels as needed.
C
to CH6.
to VR(D).
Repeat as required.
Return to the home screen.
Where next?
(Other functions you may wish to set up for your model.)
TRAINER
p. 47.
Multiple wing or tail servos. See wing types and tail types: p. 51, 56.
OFFSETS
, BUTTERFLY(AIRBRAKE
FURZ DQGRWKHUSURJUDPPDEOHPL[HVS
Retractable Gear, Smoke systems, kill switches, and other auxiliary channel
setups: p. 46.
Adjusting SUB-TRIMs to match servo centers: p. 49.