Futaba 10CG 2.4GHz User Manual
Page 13
13
N O T E : I f y o u n e e d t o re m o v e o r re p l a c e
the transmitter battery, do not pull on its
wires to remove it. Instead, gently pull on the
FRQQHFWRU
V SODVWLF KRXVLQJ ZKHUH LW SOXJV LQWR
the transmitter.
Battery connector location
Charging jack
Trainer function
connector
Battery cover
NT8S
Ni-Cd battery
pack
SWITCH ASSIGNMENT TABLE
• The factory default functions activated by the switches and knobs for a 10CAG Mode 2 transmitter are shown below.
• Most 10CG functions may be reassigned to non-default positions quickly and easily.
• Basic control assignments of channels 5-10 are quickly adjustable in AUX-CH (see p. 46). For example, the channel 5
servo, which defaults to SWITCH E for retract use, can easily be unassigned (NULL) to allow for easy use as a second
rudder servo in a mix, or to a slider or dial for bomb door or other control.
• Note that most functions need to be activated in the programming to operate.
• 10CAG Mode 1, 10CHG, and 10CG transmitter functions are similar but reverse certain switch commands. Always
check that you have the desired switch assignment for each function during set up.
Switch/Knob
A or H
Airplane (ACRO)
Sailplane/Glider (GLID)
Helicopter (HELI)
SWITCH A
elevator dual rate
ch10
elevator dual rate
GRZQ EXWWHUÀ\RQ
ch10
elevator dual rate
ch10
SWITCH B
rudder dual rate
ch9
rudder dual rate
ch9
rudder dual rate
ch9
SWITCH C
up = ELE-FLP on
FHQWHUGRZQ IDLE-DOWN
down = AIRBRAKE on
up = ELE-FLP on
center = Distance cond.
down = Landing cond.
governor
SWITCH D
aileron dual rate
aileron dual rate
aileron dual rate
SWITCH E or G*
ODQGLQJJHDUFK
WKURWWOHKROGFK
SWITCH F or H*
VQDSUROOWUDLQHU
trainer
WUDLQHUTHR-CUT
SWITCH G or E*
none
up = Speed cond.
down = Start cond.
idle-up 1 and 2
SWITCH H or F*
none
LGOHXSJ\UR
KNOB A
ÀDSFK
ÀDSWULPLIFLAPERON on)
ÀDS
ch6
HOVERING PITCH
KNOB B
ch 8
ch 8
ch 8
KNOB C
VSRLOHUFK
(disabled if AIL-DIFF on)
ch 7
(disabled if AIL-DIF on)
HOVERING THROTTLE
ch7
SLIDER D
none
ch 5
none
SLIDER E
none
none
HI-PIT
*On the 10CAG Mode 2 transmitters, the TOP LEFT SWITCHES are spring-loaded and 2-position; on the 10CAG Mode 1, 10CHG, and 10CG,
those switches are on the right side. For consistency, the switch position’s designation remains the same (upper left is F, etc), but the functions are
moved to match the switch type.