Futaba 10CG 2.4GHz - Manual (Page 35)

35
Modulation select (MODUL): sets the type of modulation transmitted.
The modulation of your receiver will determine whether you utilize 2.4G-10CH or 2.4G-7CH setting in MODUL during
transmission. Note that you have to turn your transmitter off and back on before a modulation change becomes effective.
Be sure you understand and set the FailSafe (F/S ) settings as you intended (see p. 50).
2.4G-10CH 7CH = FASST-2.4GHz system (10CHPRGH7CH mode)
Adjustability:
• 2.4G-10CH setting for all Futaba FASST-2.4G Multi-ch mode receivers,
UHJDUGOHVVRIQXPEHURIFKDQQHOV LH5+65+65)65)6 
• 2.4G-7CH setting for all Futaba FASST-2.4G 7ch mode receivers, regardless of
QXPEHURIFKDQQHOV LH5))5))05)65)6 
NOTE: When you change models in MODEL SELECT, if the new model is set to the other modulation type,
\RXPXVWF\FOHWKHWUDQVPLWWHUSRZHUWRFKDQJHPRGXODWLRQV7KHPRGXODWLRQZLOOÀDVKRQWKHKRPHVFUHHQ
to remind you until you do so. See p. 30, MODEL SELECT, for details.
GOAL of EXAMPLE: STEPS: INPUTS:
Change model 1 from 2.4G-10CH to
2.4G-7CH
.
Confirm you are currently using the
proper model memory (Ex: 1) On home screen, check model name and
number on top left and the modulation
on top right. If it is not the correct
model, use MODEL SELECT, p. 30.
O p e n B A S I C m e n u , t h e n o p e n
PARAMETER
submenu.
for 1 second. (If ADVANCE, again.)
to 2nd page of menu.
C to PARAMETER.
Go to MODUL and change setting. C to MODUL. to 2.4G-7CH.
cycle power ÀDVKHVRQVFUHHQ
Close menu and cycle power.
POWER OFF. POWER ON.
Where next? Now that the model is in the proper modulation, the T10CG should communicate
ZLWKWKHUHFHLYHU,ILWGRHVQRWFRQ¿UPWKHW\SHRIWKHUHFHLYHU
Change MODEL TYPE
WRJOLGHUKHOLFRSWHU VHHS
Set F/S settings for when 2.4G receiver sees interference: see p. 50.
Utilize servo REVERSE: see p. 38.
Adjust servo travel with END POINT: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDO D/R,EXP): see p. 42.