Futaba 10CG 2.4GHz User Manual

Page 112

Advertising
background image

112

servos.

&KDQQHOVZLWFKVHOHFWLRQDQGGLUHFWLRQFRQWURO6HHAUX-CH. ...................................................................................... 46

Channel delay: see THROTTLE DELAY (ACRO) and DELAY(HELI).

Charge: to increase the electrical energy, measured as voltage, available in a battery pack. See Battery care and charging.

Condition: (HELI

VHSDUDWHÀLJKWVHWXSWKDWKDVVLJQL¿FDQWDGMXVWDELOLW\VHSDUDWHIURPWKHEDVLFPRGHOVHWXS6HHIDLEUP 1, 2,

3

and THROTTLE HOLD.

Contact information, North American Service Center. .......................................................................................................... 3

Copy model: see MODEL COPY.

Crow: see BUTTERFLY (GLID) and AIRBRAKE (ACRO).

Cursor: See SELECT BUTTONS.

Curve Mix: a mix that does not have the same reaction at all points along the master channel. See Programmable mix.

Cyclic: horizontal controls on a helicopter. Cyclic pitch is typically called elevator. Cyclic roll is typically called aileron.

'DWDUHVHWHUDVHDOOGDWDLQDVSHFL¿FPRGHO6HHRESET.

DELAY

: (HELI) slows the servo’s reaction time when changing from one condition to another. Eases any “jumps” in transition

from one pitch setting to another, etc. Also see THROTTLE DELAY, p. 59 (ACRO). ................................................................ 103

Delta peak charger: common name for a specialized charger designed and required to properly peak charge both NiMH
and NiCd batteries, actually called a Zero Delta V Peak Charger. See Battery Care and Charging.

Dial: transmitter’s rotary control and button used in various ways during programming. .................................................. 11

Dial mix: mix that uses a knob or slider as the master control, moving the slave servo based upon the movement of the
knob or slider. See Prog. mix.

Differential: uneven movement in each direction of a control surface. Usually used when discussing ailerons or when
describing an undesirable unevenness in movement of other controls. See Twin aileron servos.

'LRGHDQHOHFWURQLFGHYLFHZKLFKRQO\DOORZVFXUUHQWWRÀRZRQHGLUHFWLRQ8VHGWRSURWHFWUDGLRDJDLQVWSRZHUVXUJHDQG
reversed polarity during charging. ....................................................................................................................................... 15

DIR-SW

: switches that change between the four separate directions of snaps available. See SNAP ROLL.

Discharge: to deplete the electrical energy in a battery pack, usually to its lowest safe voltage, for storage or as a part of
regular maintenance. See Battery care and charging.

DP16K: see CAMPac.

Dual aileron servos: (ACRO

GLID) a model using two servos on two separate channels to operate ailerons. May include

ÀDSHURQDFWLRQRUDLOHURQGLIIHUHQWLDO6HHTwin aileron servos. ........................................................................................ 51

Dual elevator servos: (ACRO

  GLID) a model using two servos on two separate channels to operate elevators. Includes

elevon, V-tail, ailevator. See Twin elevator servos. ............................................................................................................. 56

Dual rates (D/R,EXP

UHGXFHLQFUHDVHWKHVHUYRWUDYHOE\ÀLSSLQJDVZLWFK RUE\VWLFNSRVLWLRQ 8VHGWRPDNHPRGHOPRUH

FRPIRUWDEOH WR À\ LQ GLIIHUHQW PDQHXYHUV  &* VXSSRUWV WULSOH UDWHV E\ VLPSO\ DVVLJQLQJ GXDO UDWHV WR WKUHH SRVLWLRQ
switches. Includes exponential function, see EXP. ................................................................................................................ 42

Elapsed Time Counter reset: see TIMER. ............................................................................................................................... 45

ELE1/2/3/4

: designation for the individual servos that are being commanded by the elevator command. Ex: when using

elevon, the two wing servos are acting as elevators 1 and 2. See Twin elevator servos.

Elevator: surface which controls the model’s rate of climb or descent. Also called cyclic pitch on helicopters.

Elevator-to-airbrake mix: (GLID) used to allow the model to loop even tighter on elevator input by having airbrakes work with
elevators. Not a preprogrammed mix. See Programmable mix. This is the default programming for one curve mix in GLID.

Advertising